Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

different oil pump springs 120-130 1967

posted by  someone claiming to be Danny on  Mon Oct 1 02:52 CST 2001 [RELATED]

As part of my rebuild, I planned to upgrade the oil pump, spring and reinforcing ring. After purchasing the spring and ring from IPD, I came across a new volvo pump for $60. Figured I'd put the spring and ring in that pump. When it came time to install, it appeared that the new pump has a slanted pickup (for later B20 and B21?) Anyway it didn't fit inside my B20E oil pan. So then I was back to using my original pump, but lo and behold! the spring in my original pump is almost 3/8" in diameter. The IPD spring is 1/4" in diameter, so I can't use it in my original pump. The person I got the new pump from says to use the new pump and my old pickup, which I would do, but it means that the new spring (skinnier) would be sitting in a wider recess in the pickup (bottom) part of my original pump. Any problem with this? Bad idea?

Otherwise I need either a new pump complete or a pickup from a later pump with the recess for smaller diameter spring, or to use my original pump and forget the stronger spring. Opinions please.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New different oil pump springs [120-130][1967]
posted by  someone claiming to be Danny  on Mon Oct 1 02:52 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.