Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Proper size for socket to fit crankshaft pulley 200 1986

posted by  someone claiming to be Bearnoel on  Wed Feb 6 02:53 CST 2002 [RELATED]

What is the correct size of wrench or socket to turn the main crankshaft pulley
which drives all the belts on a b230 f motor.
I read somewhere in the archives that the correct size was 22mm but when I tried that it felt too small . Iwant to turn the pulley so as to turn the engine without using the starter.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Proper size for socket to fit crankshaft pulley [200][1986]
posted by  someone claiming to be Bearnoel  on Wed Feb 6 02:53 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.