Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Turbo cooling mods 200

posted by  someone claiming to be Mark on  Mon Mar 25 20:00 CST 2002 [RELATED]

Ok Turbohaulics! I switched the pump pulley to a smaller diameter 740 Turbo pulley to increase rate of flow. I have a GM elect. puller fan. The fan shroud is not as wide as the radiator. How can I fabricate a wider shroud, and seal in between the intercooler and radiator? What materials have you used? I removed the pusher fan as it was weak and I used the wires for my primary puller fan.
It still aproaches the red line on the temp gauge when climbing steep long grades using enough boost to maintain 80MPH.

Thanks,
Mark (thermostadt is 87 degrees C ) (60% distilled H20 to 40% Shellzone and Watter Wetter)(Mobil 1/Mann Filter)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Turbo cooling mods [200]
posted by  someone claiming to be Mark  on Mon Mar 25 20:00 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.