Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

AW70 overdrive solenoid wiring? 200 1992

posted by  JetDriver on  Thu Mar 28 12:14 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jul 25 08:59 CST 2011
[RELATED]

I've got the overdrive solenoid partially removed. As I was removing the clamp from the pax side of tranny I discovered bare wire rubbing against the transmision. If the wire has grounded here would that cause the overdrive not to work? I'm shy about electrical problems since I've repaired some that did not work correctly. Should I just cover the exposed wire with heat shrink after cutting and splicing or just wrap with electrical tape? The electrical tape probably isn't up to longevity with oil seepage nearby. I'm worried that splicing will cause more problems. I've experienced problems before with crimp type splicers. Also, I've got a used solenoid in case this one is bad. Thanks for the input.

Electrically Challenged
--
92 244 lowered, Bilsteins, IPD sways, Unitek cam/header, TSW Revo 18x8's 76 Datsun 280Z lowered, modified head, cam, headers, intake






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AW70 overdrive solenoid wiring? [200][1992]
posted by  JetDriver  on Thu Mar 28 12:14 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.