Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2018 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear Bilsteins and control arm spacers 200 1983

posted by  borowsm on  Thu Apr 11 13:44 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 21 13:54 CST 2001
[RELATED]


Last night I put on new Bilsteins to replace the well worn rear shocks on my 242Ti. All was fine and dandy except for the spacers between the rear control arm and the shock. With the Bilsteins, they were about 1/4" too long. The only solution I came up with was to trim the spacers to fit using a trusty hacksaw. Now I think maybe I was a little too hasty. Has anyone else encountered this? Everything was snug when it was tightened up, but is there another spacer out there I should have used?

I also re-used the nuts. Should I have replaced them with new ones?

Thanks,
Mark






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear Bilsteins and control arm spacers [200][1983]
posted by  borowsm  on Thu Apr 11 13:44 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.