Greetings All,

I went to buy clutch parts for our 83 244T this PM and found out that my source recommends the same kit (SACHS #242-04) for both the NA and the Turbo (215 mm disc and P-Plate). I know that the factory parts have different #s, but am curious as to the actual / physical difference (i.e., Turbo's P-Plate has more clamping force, etc.). I'd like to think my parts source is selling the turbo parts to put in all of the M-46 (non-intercooled) cars--but know that's probably wishful thinking.

FWIW, I'm already planning to resurface the flywheel, plus check the condition of the level and cable. T-O bearing and pilot bearing will both be replaced, as will the raer main seal. Anything else I should look at?

In terms of "bottom-line," I can get the SACHS kit for about $90 locally, while the B21FT kit (available through IPD) is $239. I don't want to be "penny-wise, pound-foolish," but is the difference worth the cost?

Any insight (esp BTDTs) would be appreciated.

Thanks in advance!

Steve A-
--
Steve Anderson (3 x 83 + 91 = 700k+ miles)