Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

LH2.2 Main FI Relay Location 200 1985

Bricksters,
Question Summary:

1. Where is the LH2.2 main system relay? (RHD car)
2. Is 7 Ohms good enough reeding on all ECU earths.
3. How do you get the A/C switch out? (it is really big)

Thanks
Karl 86 245 188K KM


I finally got a hold of the Bentley manual, great. I am trying to track down my idle problem (starts at 700RPM, drifts up to about 1100RPM when hot and surges 100RPM). I did the ECU electrical tests and only found a problem with the Air Con switch (showed earth (7 OHMS) when off (should be discontinuous), 1.2 OHMS when on) this could be teliing ECU air is on all the time, I have a problem with RPM dropping when I turn it on). BTW all earths showed 7 OHMS, is this good enough?
Anyway to my question, where is the LH2.2 main system relay? I can not complete the tests without probing it. Manual says it looks the same as the fuel pump relay and is located under the glove box RH side. Here is the trick, my car is RHDrive (Australian Car) so that location is the steering, I have had a good look both sides without luck.
Any suggestions how to get A/C switch out would also be appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New LH2.2 Main FI Relay Location [200][1985]
posted by  sandkv  on Mon May 20 12:14 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.