Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

'86 744gle w/ 87 wiring harness..An update.. 700

Thanks to everyone's help for my post on subject last month and now here's an update.
1. The 87 wiring harness will work for the '86 w/ minor modification of the temperature sensor connector.('86 has single spade connectors while '87 has an oblong w/ two round female connectors).Just improvise a spade connector(can't remember the wire color right now)for that purpose and it's done.Now there will be an extra connector by the ignition coil that will be unused (this is the other end of the wire that was not used at the temperature sensor).
2.I had high idle problems after the install and turn out to be a malfuntioning
Idle motor.I drove it for a month w/ the idle motor disconnected and yesterday got a used one from the boneyard and everything is fine now.
Thanks a lot again for all the help and if anybody is thinking of a wiring harness job,don't get intimidated if I can do it anybody can.
--
ReySC..'86 744 GLE ..'94 944 T http://communities.msn.com/Reysc/reyscarfriendshobbies.msnw?action=ShowPhoto&PhotoID=19






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New '86 744gle w/ 87 wiring harness..An update.. [700]
posted by  reysc subscriber  on Tue May 21 07:28 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.