Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

About OBD-I 900 1995

posted by  Macaroon on  Tue May 21 09:25 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I have all the tables and procedures for checking error codes
on the '95 940 OBD-I, but no matter what I do, the red led
just stays on. It never blinks, it doesn't go out until I take
the connector out.

I have checked all wiring and connections to the box itself, and
as far as I can see with my humble knowledge of electronics, there's
nothing wrong with the connectors.

Where is the chip that does the "math" for this diagnostic unit? Could
it be that this is failing?

Well, any ideas would be appreciated, as I'm trying to get the codes
for the ignition system, and no codes shows up.


Regards,

Vegar Johansen

'95 940LT, best car in the world :)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New About OBD-I [900][1995]
posted by  Macaroon  on Tue May 21 09:25 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.