i have tried everything and read all i could about this procedure and now i am stuck. we jacked the rear end of the car up and took the four bolt out of the rear of the driveshaft and pulled it out of the front section (after marking the allignment). but now we are stuck. the rubber on the old support ring was already ruined so we pulled the metal part of the ring from the rubber. big mistake! now we can't get the bearing off the driveshaft AND i cant put the old one back together to drive it to a garage. we have tried to take the front section of the driveshaft off too but the bolts are so tight that they are starting to strip. what can i do now???