Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Shock absorber replacement 200 1987

posted by  MJN on  Tue Aug 13 03:51 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

My first Ramblings:

I have a 240 GLT UK Spec and am replacing the failed front shock absorber inserts. The new units are Boge Turbo Gas Units but have a smaller diameter piston shaft than the very wide volvo originals. The trusty manual shows the new thinner type like I purchsed, however it shows these fitted in the strut with a rubber grommet on the base of the shock insert and a rubber bumper to the top. My volvo originals had neither of these?
My Volvo dealer does not recognise the old units clearly marked volvo but can sell me a steel alternative top the rubber grommet shown in the manual. Can someone shed any light on this?

Also will I need to buy the rubber bump stops or can I get away without fitting these?

Thanks in anticipation





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Shock absorber replacement [200][1987]
posted by  MJN  on Tue Aug 13 03:51 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.