Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

LH 2.4 Jetronic ( ECU ) Engine B230 F3 200 1989

posted by  someone claiming to be I am the owner of a Volvo 240 GL / 89 on  Wed Sep 11 17:02 CST 2002 [RELATED]

The 2.4 Jetronic does not give pulses to the injectors. With the ignition on,the injectors are open like under fulspeed driving . I checked every wire connection between the ECU and EZ116 K ( Ignition Modul ) and all the sensors,everything is OK.The engine starts ,but after seconds it stalls because it gets to much fuel.The Diagnosis system (Pin 6 ) gives the code 1-4-4 what means no load signal.The replacement of the Jetronic 2.4 with a secondhand one did not change the situation.I have replaced the cooland sensor ,throttle position switch( all new parts ).The Airmassmeter , pin 3 reeds 1.3 Volt with ignition on ,and 2.5 Volt in starting position.This situation has develloped without any signs from one day to another day.
Has anyone solved a similar problem ?
every useful advice is very much appreciatet.

regards Lothar







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New LH 2.4 Jetronic ( ECU ) Engine B230 F3 [200][1989]
posted by  someone claiming to be I am the owner of a Volvo 240 GL / 89  on Wed Sep 11 17:02 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.