Volvo RWD 1800 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2003 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

B20 head coollant passages 1800

I pulled the head off my '70 1800 with a B20E to replace the seals in the water pump and was looking at the head. About 18 months ago I had hardened seats installed and the ports enlarged. At that time I discovered a pipe in the head that was loose. The machinist was able to secure it in place and life was good.

Now I have the head off and I think it may be loose again, but I can't recall for certain it's the same one. When I stick my finger in the thermostat hole on the top of the head and towards the spark plug side of the engine, I feel a tube that protrudes towards the front of the engine, perhaps all the way to the freeze plug. I cannot tell for certain. It rattles about a bit but I cannot move it fore and aft.

Should this pipe be further back in the head? Could its displacement cause symptoms other than overheating, such as coolant loss into the oil? I've not experienced either problem, so I wonder if I'm OK. Even so, I can't shake the feeling that this pipe is in the wrong place. Is it?

Thanks.
--
Justin 70 1800E, 66 122E
Read vclassics!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B20 head coollant passages [1800]
posted by  justin  on Fri Oct 4 09:09 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.