Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Questions for those who have graduated blower motor school 200

posted by  Bob Wennerstrom on  Sat Oct 5 12:36 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 15 12:01 CST 2011
[RELATED]

I'm in the middle of my job. Looks like another 8 hours or so and I'll be done, Somebody get my diploma ready!

Question 1) Who has removed their dashboard to do this job? I took mine out but removed it last to access the recirculating flap vacuum motor. Can I reassemble the whole ductwork system and then put in the dash? Seems easier to get to everything with it out but don't want to reassemble and then find out I can't put the dash back in.

Question 2)Preliminary inspection indicates not enough blower shaft into the passenger side of the heater box, the fan hits the shroud. I had to cut off the nubs like in 81-85 cars for the Siemens motor to fit. I'm pretty sure I got them all flat. Are the wires on the new motor supposed to stick out the driver's side of the heater box or did I put it in backwards?

My elbows hurt, back to crawling around in the floorpan tomorrow!

Bob
82 intercooled turbowagon 234K
75 dashboard and ventilation system parts on the garage floor.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Questions for those who have graduated blower motor school [200]
posted by  Bob Wennerstrom subscriber  on Sat Oct 5 12:36 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.