Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

thread size for header pipe? need to ask again 200 1987

posted by  guri r on  Sat Oct 5 14:35 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 8 22:46 CST 2014
[RELATED]

Installed a new Bosal header pipe purchased from FCPGroton, but lack a single bolt. If anyone knows the thread size for the hole in the plate welded to the upper surface of the dual pipe in front of the flange connection to catalytic converter, would appreciate informaiton. This plate connects to the bracket that attaches to the transmission. Bolt screws straight down into this plate. Header pipe made in Canada; perhaps not metric.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New thread size for header pipe? need to ask again [200][1987]
posted by  guri r subscriber  on Sat Oct 5 14:35 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.