Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

rusted roof 200 1988

posted by  GeorgeA on  Mon Oct 28 23:51 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Blasted roof rack, rather those ribs on the roof! Took them off too late, and there are five holes on the roof, the size of a coin.

The panel beater's alternatives are: (1) cut out the whole section and weld in another sheet (over 1000 Aussie dollars), or (2) fill in all holes after sanding to metal and treating (450 Aussie dollars). The success of the latter is unpredictable, but the chances are still better if done by a professional than if I attempted it.

I am looking for other options. So far I could think of one: cutting the middle of the roof out of a wreck and gluing the skin on the holed roof with epoxy, sanding the edge and painting it. The stepped appearance would not bother me, but would this solution last? Would the existing rusty holes underneath get bigger?

Thanks for suggestions,
George Antony






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rusted roof [200][1988]
posted by  GeorgeA  on Mon Oct 28 23:51 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.