Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rotor stuck on hub 200 1988

posted by  someone claiming to be adrian on  Wed Oct 30 02:46 CST 2002 [RELATED]

Hi all! The right front wheel bearing went south yesterday on my 88 244 DL. To make a long story short, I can't get the rotor off of the hub. The rotor comes out until it is flush with the ends of the lug nuts and stops. The whole setup has been sprayed with cyclo rust eater and still it won't come off (even with persuassion from a 3lb sledge hammer) I did this job before on the left side and I don't remember it being so difficult.

Am I missing something here? Thanks in advance for any responses.

Adrian





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rotor stuck on hub [200][1988]
posted by  someone claiming to be adrian  on Wed Oct 30 02:46 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.