Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

soft brake pedal 200 1980

posted by  bderrick on  Wed Nov 20 16:01 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

In an attempt to restore my braking system, I have replaced all four calipers, several metal brake lines, all rubber brake lines and the master cylinder. Everything seems to have fit and installed properly. I bench bled the master cylinder. I bled the system with a power brake bleeder and the pedal still goes to the floor when I start the engine. Please help, I'm not sure what to do next. Does anyone have a diagram of the front brake hoses from the pressure differential warning valve to both front brakes, I'm a little concerned I may have crossed the metal lines going to the right front brake but I am not sure.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New soft brake pedal [200][1980]
posted by  bderrick subscriber  on Wed Nov 20 16:01 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.