Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Should there be quite a bit of coolant in the intake manifold 700 1987

posted by  nanolund on  Sun Dec 1 22:30 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

While looking for the idle air valve on another mission, on the underside of the intake manifold I took out this thing that I think is a temperature sensor, and out came gushing 300 mls of coolant water. Is this normal? The sensor looks like a big copper bolt with 2 electrical connections. One goes to earth and the other I presume is a live wire.

The car seems to run fine except it idles low at start up and then idles between 2000-3500 rpms. Someone in the forum suggested that I check out the idle air valve. Incidently I cannot find the idle air valve underneath the intake manifold. But I did find a thing that is mounted on the engine side with 2 vacumn hoses and an electrical connecter. Could this be the valve?

The engine is a B230K, manual, 150K miles, 2b5 pierburg carb.

Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Should there be quite a bit of coolant in the intake manifold [700][1987]
posted by  nanolund  on Sun Dec 1 22:30 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.