Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Intake Manifold Torque Specs? 200 1981

posted by  DougC on  Thu Dec 26 16:06 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 10 08:30 CST 2014
[RELATED]

1981 242 B21F: My parts should be here any day so I can start putting this thing back together. I can't find torque specs for the intake manifold on this engine. What's the best procedure? I don't think I can get a straight shot at all the nuts with a torque wrench anyway. I remember that the intake manifold nuts did not seem to be on very tight when I removed them. Also, regarding the engine temp sensor below #2, does the new one go in with bare clean threads? I think someone suggested a little anti-sieze on the threads.?.?
--
Thanks to everyone for all the help given, Doug C. 81 242 Brick on Blocks, stock; 86 240, 129K, pictured in Rolling once, now has smashed left quarter panel thanks to the driver of an F150. Daughter safe in her Volvo.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intake Manifold Torque Specs? [200][1981]
posted by  DougC  on Thu Dec 26 16:06 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.