Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Alternator and Sender Wire Replacement 200 1981

posted by  DougC on  Sun Dec 29 17:59 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 10 08:30 CST 2014
[RELATED]

My 242 is showing symtoms of the harness disease. I'm waiting for a good harness from Dave Barton, but I'd like to fix the wire that plugs onto a spade connector at the top of the back of the alternator in the meantime. Also, I plan to replace the one that feeds the sender next to the oil filter. I'm figuring on clipping these two and rerouting them outside the harness sheathing. I don't want to mess anything up. Can anyone tell me where the best place to tie in the new wires would be? Where do these two wires end up? What gauge wire should I use for these two?
--
Thanks to everyone for all the help given, Doug C. 81 242 Brick on Blocks, stock; 86 240, 129K, pictured in Rolling once, now has smashed left quarter panel thanks to the driver of an F150. Daughter safe in her Volvo.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Alternator and Sender Wire Replacement [200][1981]
posted by  DougC  on Sun Dec 29 17:59 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.