Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2013 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Still won't start - Help! 700 1989

The history on my (new to me) '89 740FT is 119,000, and a clogged PVC system.

So I removed all of the intake system from the airbox to the turbo and from the intercooler to the block (that is, I removed the intake manifold.

Put all back together and the engine ran fine for abot 20-30 minutes before I shut it down.

New intake manifold gasket; cleaned the injectors and installed new seals; cleaned & adjusted the throttle body and used new gasket; cleaned the PVC system; Inspected hoses and wiring =OK; cleaned grounds; Looked at FPR for any gas leakage on vacuum side = "NO"; checked all coil and distributor wires sof tightness; regapped plugs; etc.

Now it won't re-start.

Cranks well. Acts like it's getting no gas, or there is a massive vacuum leak (like a big hose off somewhere = Not). Will *almost* start once, or when I shoot in some carb cleaner. Tach does bounce while cranking.

Pulled and inspected the FI relay. Looks OK. Jumped pins 30 and 87/2 and have both pumps running.

So, now what?
--
1989 740Ti 1986 240DL 1984 244GL






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Still won't start - Help! [700][1989]
posted by  Zee subscriber  on Sun Dec 29 23:50 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.