Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Driveshaft disconnecting 700 1987

posted by  dugal on  Tue Jan 7 14:10 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi Folks,
I would like to tow my 1987 780 Volvo with an automatic transmission using a 2 wheel car dolly (350 miles). The front wheels will be up on the dolly while the rears will be on the road. I was always told to disconnect driveshafts on auto trannys when towing this way as the tranny bearings do not get lubricated.
So, I have not seen the car yet and would like to know where would be the easiest place to disconnect the drive shaft. Just at the rear universal joint ? then wire up the driveshaft, or take the whole shaft out ? Also, anyone got any idea of wrench sizes and tools needed ?
Regards
Doug






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveshaft disconnecting [700][1987]
posted by  dugal  on Tue Jan 7 14:10 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.