Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2010

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 Rear Lense/now lights don't work...Huh?

Ok guys...moderately experienced but too often 'dumb' here.

Changed out faded, cracked right rear tail lens (with an aftermarket product)on my '90 244 this afternoon during my lunch break, which I 'thought' was a simple job.

Carefully unbolted assembly, removed foam rubber gasket, unplugged main connector, removed sockets in order..then Carefully removed and untaped the circuit board from the original lens..replaced circuit board (carefully, of course) and retaped on replacement lens...but no lights!

'didn't have time for a continuity check (parking lot at work) and I'm pretty sure I avoided damaging the circuit board during transition...but VERY frustrated/worried now....any ideas what I've done..and what I should do to 'fix' it?

All comments gratefully accepted...Thanks in advance

'66 122
'89 240
'90 240






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 Rear Lense/now lights don't work...Huh?
posted by  Dee Jay subscriber  on Tue Jan 28 09:00 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.