Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear sway bar bushing 200

posted by  dash on  Wed Feb 12 06:12 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jul 19 08:01 CST 2008
[RELATED]

I think I found the source of the clunk my 85 244 DL (133k) was making. It looks like the rear sway bar (track rod) bushing on the passenger side of the car is completely out of it's housing. I would like to change out the 2 bushings for the sway bar immediately as it is "clunking" a lot now (while turning)and in the spring change the trailer arm and torque rod bushings if they look like they need it. I really haven't looked closely at them yet.

1. Does the sway bar come out easily or do I have to get the weight off the rear axle as with the trailer arm bushings?

2. Can the old bushings be pushed out of the housing relatively easy or should I take it to a shop and have them removed and the new bushings pressed in? I pulled out the alternator bracket bushings and pressed in new ones but they were the IPD urethane type which supposedly are easier to install.

3. Is it better to get the urethane IPD replacements or Volvo OEM parts?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear sway bar bushing [200]
posted by  dash  on Wed Feb 12 06:12 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.