Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Oil Pressure Sender and Idiot Light Question 200 1985

posted by  stxavier2003 on  Fri Feb 14 10:37 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 17 14:01 CST 2007
[RELATED]

I finally got my plumbing peices and some electrical connectors so I can install my Oil Pressure gauge. I have a few questions before I dig in. Do I have to take the grommet out (on the firewall) or partially out to feed the wire through? Also, the wire for the idiot light, does the color of it stay the same all the way back to the grey block on the firewall or does it change in the middle? I plan to replace that wire, I know that all of the wires coming out of that gray connector are not doing well. Any tips or tricks you guys have would be appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil Pressure Sender and Idiot Light Question [200][1985]
posted by  stxavier2003  on Fri Feb 14 10:37 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.