Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

960 PNP Switch Replacement Question 900 1998

uid 11021's pic
posted by  dewfpo on  Sat Feb 15 09:18 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 18:34 CST 2014
[RELATED]

I've got the front of the S90 up on ramps and was scoping out the PNP switch replacement situation before unbolting things and I have a question.

I have to drop the head pipe(s)/cat. conv. to get at the PNP switch. In looking at this, the two O2 sensors are attached to the front/back of the cat. I didn't see a clip anywhere that I can disconnect these two O2 sensors. The wires from the sensors go around the trans. and up into the engine compartment somewhere. I can't believe that these things have a 3-4 foot long pigtales.

There's got to be a way to diconnect them closer to the O2 Sensor.

Anyone done this before?

Thanks
--
1998 S90 062,700 1995 964 142,100






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 960 PNP Switch Replacement Question [900][1998]
posted by  dewfpo  on Sat Feb 15 09:18 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.