Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1988 Volvo needs more help 200 1988

posted by  nmtrout on  Sat Feb 22 07:16 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

First off thanks to all that replied earlier (Feb 15 - 1988 Volvo needs help). We did not get it to pass emissions for my daughters birthday but are well on the way (I think).

One of the most common suggestions was to look at the air supply tube for holes. Low and behold there were numerous between the AMM and throttle body. I have a replacement and am getting ready to put it on but noticed the throttle plate (right inside the assembly) looks terrible - sort of like the inside of a chimney!

QUESTION (finally) - can I use a Throttle Body cleaner to clean this? Should I remove it from the car and clean it that way? Is this something that will help my HC and CO levels?

Once again thanks to all of my 'advisors'

Ted in Albuquerque






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1988 Volvo needs more help [200][1988]
posted by  nmtrout  on Sat Feb 22 07:16 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.