Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

I'm in a jam 200

posted by  dash on  Sat Feb 22 07:27 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jul 19 08:01 CST 2008
[RELATED]

I removed the pannard bar, torque rods, stabilizer bar and one coil spring and I have run into a problem. I have the car supported on jack stands in the rear jack points and the jack is under the diff. But now the diif is not setting squarely on the jack pad but is angled downwards about 10 degrees. I guess that because I have the torque rods off. I'm concerned the axle will slip off the jack pad. Greg Wong told me not to remove too much as the axle is more difficult to work with but I wanted to remove everything so I could take the rods and trailer arms to the auto machine shop in one trip for old bushing removal etc.

I will try to attach a jpeg of my situation. Thanks in advance!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I'm in a jam [200]
posted by  dash  on Sat Feb 22 07:27 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.