Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Tips, experiences with removing and working on fuel distribtors???? 200 1980

posted by  Chuck Jaxel on  Thu Feb 27 20:18 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Mar 11 15:58 CST 2014
[RELATED]

I'm going to swap out my fuel distributor with my mashed 80 system, which was working fine before the crash, What I need to know is what holds it in? Is it bolted to the block or to the intake. Looks like a large rubber inlet connects the whole mess to the intake. I'm taking injectors and lines and everything. Not leaving anything to chance. Thanks as always. 0-60 in 10.3 mins is too damn dangerous!!!
Chuck Jaxel
--
Chuck Jaxel, Pine Hill NJ, Near Philly...






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tips, experiences with removing and working on fuel distribtors???? [200][1980]
posted by  Chuck Jaxel subscriber  on Thu Feb 27 20:18 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.