Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Torque specs for back of trans AW71 700

posted by  mattw on  Fri Feb 28 17:27 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 12 12:47 CST 2001
[RELATED]

1988 760 Turbo
I am about to but the back of the trans back on after replacing the tailshaft bushing.


I need to know the torque specs for: (if they even matter...)

*the extension housing bolts
*the single bolt that holds the output flange to the output shaft
*and the 4 bolts/nuts that hold the driveshaft to the flange

If they don't matter, I'm just going to put loctite on the 4 flange-driveshaft bolts/nuts and just snug the others (I don't usually overtighten).


Thanks!
-Matt W






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Torque specs for back of trans AW71 [700]
posted by  mattw  on Fri Feb 28 17:27 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.