Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2011

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help Needed for Tool Design: Crank Diameter

posted by  someone claiming to be steve on  Sat Mar 1 03:37 CST 2003 [RELATED]

I am trying to design a seal installer for the new Viton rear crank seal, which tends to get hung up at the seal faces on installation. Can anybody with a B230 rear crank area exposed please take an accurate micrometer reading of the diameter of the crank at the seal faces? If it is worn, measure to the side so you get the "as new" crank diameter. Gracias!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help Needed for Tool Design: Crank Diameter
posted by  someone claiming to be steve  on Sat Mar 1 03:37 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.