Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Questions while installing power trunk release 200 1982

posted by  matt82dl on  Sat Mar 1 13:54 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 13 10:46 CST 2014
[RELATED]

I picked up a power trunk release motor and button on ebay for my '82 DL. Have a few questions:

1) I dont seem to see any existing wiring, were all vehicle pre-wired?

2.) If no to above, is it just a simple series circuit with the motor and switch.

3.) There are three wire coming out of the motor, a short brown which looks like a ground and then two other wires about 14" long with a connector at the end. If there is already a gound (brown) what are the other two?

4.) any other general installation tips.

Thanks,

Matt

--
'82 DL - 154k, '93 945 - 103k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Questions while installing power trunk release [200][1982]
posted by  matt82dl  on Sat Mar 1 13:54 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.