Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Oil breather removal and cleaning question 700 1988

posted by  fisher on  Tue Mar 18 01:52 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I was going to remove my Oil breather to clean it on the weekend because it was plugged. The only problem was that after removing the 2 screws that held it in, there was not enough clearence above to remove it. It would lift up so far and then hit the heater hose and still not come out. From the FAQ and pictures I had seen, I had thought just the 2 screws was all it would take.

My question is, what do I need to do to get this out? I was planning on doing my motor mounts this weekend and I have lots of new gaskets so removing the intake is fine but will that even do it? If I disconnect that heater hose how much antifreeze would I need to drain?

Thanks in advance
Stephen






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil breather removal and cleaning question [700][1988]
posted by  fisher  on Tue Mar 18 01:52 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.