Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

It's spring ... Brake work time 200

posted by  leugim on  Fri Mar 28 04:32 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 18 20:49 CST 2014
[RELATED]

I am planning on pulling my 86 244 (Old Grey Mare - she ain't what she used to be) off to due some overdue service on the front end. (Tie rod ends) While I am there I will be adding new rotors and pads, changing the bearings ( I have a set laying around).

Although I would like to get rebuilt calipers, I Do not have the $ to get these at this time. They are functioning okay.

The question I am asking concerns the rotors (vented - Girling type calipers)
I see that FPC Groton has "Zimmerman" rotors at $25 ea
I have used Brembo on my wagon that I got from Trollhattan at what I think was a good deal ($98 for two rotors pads and hardware)

I saw what Kentucy Fried posted ... any comments?

Miguel
--
'86 244 and '87 245






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New It's spring ... Brake work time [200]
posted by  leugim subscriber  on Fri Mar 28 04:32 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.