Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Leak ,I think, in the return fuel line 200 1986

There is a leak in my 240 fuel circuit. I think it is at the metal duct approximately halfway between the main pump and the engine compartment.

I presume that it is the line that brings back the fuel to the tank.
There are five lines running parallel to the drive shaft on the driver side and the leaky one is in the middle.

I presume that the high pressure line feeding the injectors is the black nylon one since the metal line does not seem to be very pressurized. If it is, it is not any more because of the leak.

Is it possible to repair the leak for now with the epoxy patching material that are sold to repair gas tanks. How complicated is it to replace that line and how should I proceed to do so .

Thanks in advance






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Leak ,I think, in the return fuel line [200][1986]
posted by  someone claiming to be bearnoel  on Sun Apr 6 08:10 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.