Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Problem starting '92 745t 700

posted by  skowsa on  Thu May 8 03:31 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Every now & then (don't we all hate that?) after starting my car it just immediately dies/stalls. The only way to keep the engine running is to keep your foot on the gas a little, then to shift into Drive and be on your merry way. This was happening before and after my head gasket replacement, at which time all belts were also replaced. Prior to that my rpm sensor was replaced - it's plastic coating had melted away and was stalling the engine all the time while driving. I have recently re soldered all the connections on the fuel pump relay and there are no engine codes. Air & fuel filters are new (within last 3 months).
Anyone able to offer a word or two of advice?

TIA
Ian






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Problem starting '92 745t [700]
posted by  skowsa  on Thu May 8 03:31 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.