Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Cruise Problems 200 1987

posted by  Ross Havel on  Wed May 14 17:57 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

The cruise in my '87 Volvo 240 has quit. All of the vacuum lines are good, and the throttle control servo and the vacuum controller under the hood both are good. The brake switch holds vacuum, and is not closing the circuit to disengage the cruise controller. I can only assume it is getting a bad speed signal, and do not know how to check this.
When looking at the back of the instrument cluster, I found 2 male spade ends connected to the same contact (one is connected to a red w/white wire), and a female connector with no wire attached. There is an orange wire coming out of the cruise control unit harness that has a female spade connector (not connected to anything), but it puts out just over 5 volts, and the red wire contact is 13. I can only assume it should not be connected to this connector.

Help Please!







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.