Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Replacing my timing belt and crank seal 200

posted by  Survivor99 on  Thu May 15 05:57 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

So, this weekend I will try to get the brick back into shape.

I will be replacing the timing belt and the front crank seal.

I have done this once before, but I am always afraid of not being able to put on the belt correctly and messing things up.

Is there an easy way to make sure things line up?

If I use white-out and mark the lines on the belt to the various pulleys and then put the belt back on, will this guarantee a correct fit?

Also what should I use to push the new crank seal into place. I believe the manual reference a special tool, but it sucks to have to pay for that just for a single use.

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing my timing belt and crank seal [200]
posted by  Survivor99  on Thu May 15 05:57 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.