Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

I replaced the A/C expansion valve but I am not sure about where to connect the sensor wire. 200

posted by  Kyle245 on  Mon May 19 09:35 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jul 10 04:45 CST 2014
[RELATED]

Hello all,

I finally got around to replacing the receiver drier and the expansion valve on my A/C system but I am not sure about where to place the temp probe that comes off of the valve.

The valve has two probes....one that connects to the evapoator out line but where should the other one go?

Also where should the temperature switch (rotary switch for temp control) sensor wire go. I saw an illustration in a A/C book show it next to the evaporator core but I am not sure if it goes before or after the core.

Thanks in advance.

Kyle245






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I replaced the A/C expansion valve but I am not sure about where to connect the sensor wire. [200]
posted by  Kyle245 subscriber  on Mon May 19 09:35 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.