Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ECU 123 (Engine Control Temp Sensor) Code Keeps Popping Up after replacement 200

I am 2nd owner of '93 245 with 134K. The engine control temperature sensor was replace by PO at 110K. I got the car at 119K and the engine check light has come on frequently and has been traced as a 123 code...engine control temp sensor. We finally replaced it last week, and the stupid engine check light has come on three times since, all reading with a 123 code....AAARRGGGH! What gives with this puppy? It seems to do it when there is a temperature change and the car seems to stumble a little and run rich, but runs fine at highway speeds.

Any thoughts from the bricksters?
John






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ECU 123 (Engine Control Temp Sensor) Code Keeps Popping Up after replacement [200]
posted by  w940  on Wed May 21 14:40 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.