Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2010

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rusted gas line clamp

posted by  jwalker on  Tue Jun 3 06:38 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jun 6 08:39 CST 2014
[RELATED]


This coming weekend I'm finally going to tackle replacing my fuel pre-pump. Could use some advise with an annoying issue.

I have been spraying the fuel line clamps with a penetrant for a couple of weeks now in an attempt to free them up. The fuel-out line clamp has a phillips head screw that will not move and seems to want to strip as soon as I apply any real torque. My real concern is breaking the sending unit fuel pipe in an attempt to get the clamp off. Sending units = real $$$

My question is what should I use to remove this clamp safely? Any thoughts?? BTW - in the archives someone mentioned using a pair of dikes. Anybody know what those are?


Thanks all,

Jim






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rusted gas line clamp
posted by  jwalker  on Tue Jun 3 06:38 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.