Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

rear caliper hardware rusted in place 200 1990

posted by  philvo on  Sun Jun 8 09:32 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 15 14:26 CST 2014
[RELATED]

I was going to replace the rear pads and the pins are rusted to the calipers.Looks like I'll be getting new hardware and drilling out the old crap,unless someone has a better suggestion.I tried "tapping" them out but they are stuck good.I didn't want to break the pin until I got new hardware.
--
philvo






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rear caliper hardware rusted in place [200][1990]
posted by  philvo subscriber  on Sun Jun 8 09:32 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.