Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Turbo oil feed pipe question 700

posted by  Cisco on  Wed Jun 25 02:09 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jan 2 09:16 CST 2008
[RELATED]

In my persuit to finish putting my car back together, I decided to get a new turbo oil feed pipe instead of futzin' with the old one. I ordered one from Importec. They only offered one type as opposed to FCPGroton offering two (no pics, though, to compare.)

The question is that the new one appears to use less pipe but the end points appear to, well, end at the same locations. The new one is just bent differently. My problem is that I don't have the manifold and turbo together yet and, obviously, not on the block. So I can't check to see if the new path will work.

Has anyone used this new bend yet? I have a Mitsu TD05 turbo. The pipe part no is 1378677 (B4011-63576 is the importec number)
Thanks!







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.