Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bushing dimensions-'Makin Drifts' 200 1990

posted by  billn on  Wed Jun 25 04:35 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Anybody got 'da dimensions for all the front/rear bushings for my daughter's '90 240 DL? Try'in to fabricate "drifts", sockets etc. to push out/install busings.

Will be do'in a complete bushing job with a 20 ton press on sale at Harbor Freight for $169.99(Lot# 328479) and my "new" "Homebrew Tool" for the Trailing Arm buhings Thanks to Neal W., Art B. Jim H and Don F for the Homebrew Tool.

Think Don had a set of "drifts" made for the front/rear bushings, but can't seem to find the dimensions. If anybody has measured the bushings, sure would appreciate the dimensions OD, ID and length so I can duplicate the Volvo "special bushing tools" that they think so highly of at $404.23!!

If anybody used homemade drifts,sockets, pipe couplings etc. to remove/install the suspension bushings, what sizes did 'ya use for each of the front/rear bushings? Thanks for ya'alls help!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bushing dimensions-'Makin Drifts' [200][1990]
posted by  billn  on Wed Jun 25 04:35 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.