Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2021 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Flywheel placement 700 1989

posted by  Cisco on  Tue Jul 1 10:40 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jan 2 09:16 CST 2008
[RELATED]

Hello everyone!
I read thru the FAQs on this subject but I'd like a bit of reinforcement. I marked everything when I removed the flywheel only to find that the center piece comes out as well. I didn't mark that in relation to the shaft before it fell out.

Anyway, this is what I did and hopefully it's right.

I set the motor to TDC and installed the flywheel with the arrow pointing towards the top of the motor. My concern lies with the position sensor and little nubs connected to the flywheel. These nubs are now positioned on either side of the sensor which is located opposite the starter (on the exhaust side of the motor).

Basically, all I am looking for is this...did I install it correctly? I removed everything to replace the rear main seal.

Thanks!
--
1989 740 Turbo Intercooler Wagon, B230FT, 165K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Flywheel placement [700][1989]
posted by  Cisco  on Tue Jul 1 10:40 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.