Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2007 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M41 seal jitters 120-130

posted by  someone claiming to be Erik on  Wed Jul 9 03:16 CST 2003 [RELATED]

Thanks to everyone for the help so far in the conversion to o-drive.
With the shaft getting shortened I am now looking at the M41. I had a great idea of replacing all the seals before I install it so it could stay in the car for many years. However, after looking at the diagrams I am nervous about replacing the middle seals in the o-drive unit for fear of having to dismantle the entire unit to replace two seals.
Any suggestions, has anyone else done the seals only? The unit tested good in a mule car, just some leaking. My thoughts are that if I have to take the entire thing apart it should be rebuilt, but I do not have the time at the moment.
Thanks,
Erik





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M41 seal jitters [120-130]
posted by  someone claiming to be Erik  on Wed Jul 9 03:16 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.