Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

question on timing belt changing 700 1989

posted by  di_rosa on  Thu Jul 17 12:40 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

hi,
i just finished changing the timing belt on my 1989 760ti wagon with 300K on it. when i started it up, it sounded perfect, in fact, better then it did before. but when i drive, it seems to be knocking a lot more than it previously did. i'm gonna align the crankshaft with the 0 degree mark, and take off the top timing cover to see if the mark matches up, but i know i didn't get the intermediate shaft right on with the mark. is it important? i think i remember reading it was for turning the oil pump, so i wasn't that concerned. my knock sensor is bad, i know that, and i did have a LOT of knocking before, but now it seems to have doubled.

thanks for any thoughts,
di_rosa






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New question on timing belt changing [700][1989]
posted by  di_rosa  on Thu Jul 17 12:40 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.