I had a no start situation the other day and just happened to have a friend's Noid kit in the car from Snap-On.

I could hear the pump relay come on and the pump running so, I popped a Noid on one of my fuel injectors and behold and low! No blinking light!

I traced it to a bad connection on the ECU. Cleaned up the connector, a little touch of dielectric greese and I was back in business.

This Noid turned a 30 min. - 2 hr. hunt into ten minutes. "I gotta have one 'O these!", I thought to myself.

Snap-On wants a small fortune for the things so, I thought I would just build one. What could there be to it? I just need a defunct injector for my base, cut it in half to get to the wires and just wire in a LED and resistor, seal it with something water/oil proof and clear or opaque and Bob's your uncle!

Whilst searching for a few parts for this and another project, I ran across this place:

http://www.sjdiscounttools.com/ta36310.html

I think I will just buy the kit from these guys.

Thought a few people around here might appreciate the link.

Gambit...