Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Okay, the wiring is fixed... 200

posted by  ChiefQM on  Fri Aug 22 07:58 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 25 09:04 CST 2012
[RELATED]

Okay, I got the wiring harness repaired, the flame trap replaced, but was unable to solve the main reason I got under the hood in the first place - bad coolant temp sensor. How in the heck do you get that thing out of there? I really don't want to take the intake manifold off, but I can't get a socket (3/4") on the main part of the sensor because the plastic doodad where the wires connect is too big. I can't get a open end wrench to stay on it because of all the stuff (knock sensor, flame trap, other lines and hoses) in the way. Is there a special tool that can be had inexpensively? Any tips/tricks would be appreciated.

Bill
'85 244 GL






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Okay, the wiring is fixed... [200]
posted by  ChiefQM  on Fri Aug 22 07:58 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.